Cisco SCE8000 GBE Installation And Configuration Manual page 31

Chapter 2 Introduction to the Cisco SCE8000 GBE Platform
For an illustration of the 8-Port GBE SPA Interface Module refer to
Figure 2-5
1 A/L (Active/Link) LED
Table 2-7
Table 2-7
Port
GBE Line port eight on each
Table 2-8
LEDs
Active/Link (1)
Status (2)
OL-19897-02
8-Port GBE SPA Interface Module
1
lists the SPA port information and
SPA Ports
Quantity Description
Any one of the following:
SPA
•
•
•
CLI designation: interface
TenGigabitEthernet 3/0/0-7,
3/1/0-7, 3/2/0-7, 3/3/0-7.
SPA LEDs
Description
• Green —Port is enabled by software and the link is up.
Amber — Port is enabled by software and the link is down.
•
Unlit — Port is not enabled by software.
•
The Status LED indicates the operational status of the SPA module, as follows:
Green — SPA is ready and operational.
•
Amber — SPA power is on and good, and SPA is being configured.
•
Off — SPA power is off.
•
2 Status LED
Table 2-8 lists SPA LEDs and describes their indications.
SFP-GE-S
(1000BASE-SX SFP
(DOM))
SFP-GE-L
(1000BASE-LX/LH SFP
(DOM))
SFP-GE-Z
(1000BASE-ZX Gigabit
Ethernet SFP (DOM))
Cisco SCE8000 GBE Installation and Configuration Guide
Modular Optics
Figure 2-5.
2
Connect This Port To...
Any one of the following:
Subscriber side network
•
component
Network side network component
•
Optical bypass GBE line port
•
• 10GBE line port of a cascaded
SCE8000 GBE platform
Refer to Connecting the GBE Line
Ports to the Network, page 6-2
further information.
for
2-9