Cabling The Gbe Line Ports And Completing The Installation; Introduction - Cisco SCE8000 GBE Installation And Configuration Manual

Cabling the GBE Line Ports and Completing the
Installation
Revised: August 23, 2010, OL-19897-02

Introduction

This chapter provides instructions for cabling the Cisco SCE8000 GBE line ports for single and
cascaded topologies. In a cascade topology, this includes the cascade ports as well as the line ports.
The GBE line ports are located on the SPA modules, which are installed in the SCE8000-SIP module in
slot #3 of the Cisco SCE8000 GBE chassis.
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures
outlined in the section
Note When installing an External Optical Bypass module, the Cisco SCE8000 GBE line ports are connected
to the module. See
page 6-9
•
•
•
•
•
OL-19897-02
Cascaded Systems, page
Cabling the Line Interface Ports: Using the External Optical Bypass Module,
for complete instructions.
Connecting the GBE Line Ports to the Network, page 6-2
The Optical Bypass Module, page 6-4
Cabling the GBE Line Interface Ports, page 6-6
How to Install a Service Control Application, page 6-13
Cascaded Systems, page 6-13
C H A P T E R
6-13.
Cisco SCE8000 GBE Installation and Configuration Guide
6
6-1