Older Migration And Upgrade Procedures - Cisco UCS S3260 Service Manual

Older Migration and Upgrade Procedures

Older Migration and Upgrade Procedures
The procedures in this section are for migrating from M3 server nodes to M4 server nodes.
•
•
•
Upgrading From S3260 With One M3 Server Node to S3260 With One M4
Server Node
This procedure upgrades a Cisco UCS S3260 system that is using one C3X60 M3 server node to a Cisco
UCS S3260 system that uses one C3X60 M4 server node.
Items Required For This Upgrade
Hardware
•
Note
•
Software
•
•
•
Upgrade Considerations
Note the following considerations:
•
•
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
E-18
Upgrading a S3260 System With M3 Server Node to S3260 with M4 Server Node, page E-19
Upgrading a S3260 System With Two M3 Server Nodes to S3260 with Two M4 Server Nodes,
page E-23
Migrating From C3160 With One M3 Server Node to S3260 With One M4 Server Node, page E-27
A Cisco UCS S3260 system with one M3 server node and one SIOC. All chassis and server node
components must be running Cisco IMC 2.0(7) or 2.0(9) firmware before you begin the upgrade.
Migration to S3260 with M4 server nodes is supported only with chassis part-number versions
68-5286-06 and later. The motherboard in these chassis versions supports all M4 system
components.
New M4 server node running Cisco IMC 2.0(13) or later firmware (the factory default).
Up to five IP addresses, either configured in your DHCP server or manually entered for static IP
addresses. See System IP Addresses, page 2-14
The latest Host Upgrade Utility package for Cisco IMC 2.0(7) or 2.0(9) firmware. This is used to
update the entire Cisco S3260 system with M3 nodes to the prerequisite firmware.
The Host Upgrade Utility package for Cisco IMC 2.0(13) or later firmware. This is used to upgrade
the system to M4 server node requirements.
For instructions on downloading and using the utility, see the instructions in the guide for your
release: HUU Guides
After the upgrade, you must manually define drive zoning to map the hard drives to the individual
server node.
After the upgrade, your boot SSDs might lose their operating system. In this case, reinstall your
operating system to the boot SSDs.
Appendix E Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes
for more information.