Migrating From Version 02 Sioc To Version 03 Sioc - Cisco UCS S3260 Service Manual

Installing a Second Server Node or SIOC to the S3260 System With M5 Server Node

Migrating From Version 02 SIOC to Version 03 SIOC

This procedure describes how to migrate from SIOC Version 02 (UCS-S3260-SIOC) to SIOC Version
03 (UCS-S3260-PCISIOC).
•
•
Note
Note
Note
Note
Procedure Summary
1.
2.
3.
4.
5.
6.
7.
8.
Full Procedure
Ensure that the entire Cisco S3260 system with M5 server node is running Cisco IMC 3.1(3a) firmware
Step 1
before you begin the upgrade.
If the system is running an earlier version, download and run the S3260 Host Upgrade Utility (HUU) for
release 3.1(3a):
Shut down and remove power from the entire system. You must disconnect all power cords to completely
Step 2
remove power.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
E-14
The version 02 SIOC (UCSC-S3260-SIOC) uses an integrated Cisco UCS VIC 1300 Series chip
on-board, so there is no removable adapter card. There are no storage drives in the SIOC.
The Version 03 SIOC (UCS-S3260-PCISIOC) uses a removable PCIe-style adapter card
(half-height, half-length, Gen-3, x8 lane). It also supports up to two 2.5-inch NVMe SSDs and an
RTC battery.
The Version 03 SIOC is supported only with the S3260 M5 server node. It is not supported with
earlier server nodes.
Do not mix Version 02 SIOCs with Version 03 SIOCs in the same system.
If your system has two Version 03 SIOCs, they must have identical adapter cards. Do not mix
adapter cards between Version 03 SIOCs in a chassis.
Version 03 SIOCs require Cisco IMC 4.0(1n) or later and Cisco UCS Manager 4.0(1n) or later.
The upgrade process is described in the following procedure.
Ensure that the entire S3260 system with Version 02 SIOCs (and M5 server nodes) is running
3.1(3a).
Disconnect all power cords to remove power from the system.
Replace the Version 02 SIOCs with Version 03 SIOCs.
Reconnect cables and power cords.
Upgrade the entire S3260 system with M5 server nodes to 4.0(1x).
Boot the system and set CMC and BMC to factory defaults.
Configure IP addresses and network settings.
Perform drive zoning for hard drives.
HUU Guides
Appendix E Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes