Cisco UCS S3260 Service Manual page 82

Installing or Replacing System Components
When a SIOC is moved to a new chassis, the CMC settings are reset to the factory defaults and so you
Note
must perform initial setup as you would for a new system.
Power on, connect cables to the system, and log in to the Cisco IMC Configuration Utility as described
Step 16
in Connecting the System and Opening the Setup Utility, page
Configure the network settings for the system as described in
Step 17
IMC Configuration Utility, page
You can use a DHCP server to set IP addresses or set them statically using the procedure in
•
Static CMC and BMC Internal IP Addresses, page
For more information about the IP addresses in the system (up to five), see
•
page
After the system has connection to the network, use the Host Upgrade Utility to update the system to
Step 18
your desired level and ensure that all components in the system are running compatible software levels.
See the
Import the component configurations that you exported in step 1.
Step 19
Refer to the
Servers. See the chapter Server Utilities and the section Exporting and Importing the Cisco IMC and
BMC Configuration.
Verify that all configurations imported successfully.
Step 20
Verify that chassis health is optimal.
Step 21
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
3-48
2-16.
2-14.
Cisco Host Upgrade Utility Quick Reference Guide
Cisco UCS Integrated Management Controller CLI Configuration Guide for S3260 Storage
Chapter 3
2-15.
Setting Up the System Using the Cisco
2-18.
System IP Addresses,
for your firmware level.
Maintaining the System
Setting