Cisco UCS S3260 Service Manual page 119

Storage server chassis
Hide thumbs Also See for UCS S3260:
Table of Contents

Advertisement

Appendix E
Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes
Set a new Cisco IMC password when prompted.
Step 12
Configure the management, CMC, and BMC IP addresses for the system.
Step 13
If you use a DHCP server and you already have QSFP cables attached to the SIOCs, the management IP
Note
address and network settings are already filled in. If you disable DHCP, you must set your own static
management IP address and network settings.
This step only for setting static IPs (DHCP disabled)—Set the CMC and BMC internal IP addresses
Step 14
by using the Cisco IMC interface, as described in
page
Use the Cisco IMC (GUI or CLI) to define hard drive zoning, which maps the hard drives to individual
Step 15
server nodes. Use either the Cisco IMC GUI or the Cisco IMC CLI:
a.
b.
c.
Server# scope chassis
Server /chassis# scope dynamic-storage
Server /chassis/dynamic-storage# assign-drive <server ID> <drive-slotid-list>
Server# scope chassis
Server /chassis # scope dynamic-storage
svbu-huu-sanity-col2-1-vcmc /chassis/dynamic-storage # assign-drive server2 27
Are you sure you want to assign drives 27 to server2
Enter 'yes' to confirm -> yes
assign-drive operation successful.
Migrating From C3160 With One M3 Server Node to S3260 With One M4
Server Node
This procedure upgrades a Cisco UCS C3160 system that is using one C3X60 M3 server node to a Cisco
UCS S3260 system that uses one C3X60 M4 server node.
Items Required For This Migration
Hardware
2-18.
Using the Cisco IMC GUI:
Use the management IP address of the system to log in to the Cisco IMC management software.
Navigate to the following tab:
Chassis > Inventory > Dynamic Storage > Zoning
Select the drives and then assign them to Server1 or Server2.
Using the Cisco IMC CLI, enter the following commands with your choices:
For example:
A Cisco UCS C3160 system with one M3 server node in server bay 1 (the upper bay). The system
must be running Cisco IMC 2.0(8) or 2.0(9) firmware (only) before you can begin the migration.
Setting Static CMC and BMC Internal IP Addresses,
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Older Migration and Upgrade Procedures
E-25

Advertisement

Table of Contents
loading

Table of Contents