Cisco UCS S3260 Service Manual page 120

Storage server chassis
Hide thumbs Also See for UCS S3260:
Table of Contents

Advertisement

Older Migration and Upgrade Procedures
Note
Software
Upgrade Considerations
Note the following considerations:
Migration Procedure
Procedure Summary
1.
2.
3.
4.
5.
6.
7.
8.
9.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
E-26
Migration to S3260 with M4 server nodes is supported only with chassis part-number versions
68-5286-06 and later. The motherboard in these chassis versions supports all M4 system
components.
A new system I/O controller (SIOC),
Cisco IMC 2.0.13 or later firmware (the factory-installed default).
A new C3X60 M4 server node.
Up to five IP addresses, either configured in your DHCP server or manually entered for static IP
addresses. See
System IP Addresses, page 2-14
The latest Host Upgrade Utility package for Cisco IMC 2.0(8) or 2.0(9) firmware. This is used to
update the entire Cisco C3160 system to the prerequisite firmware.
The Host Upgrade Utility package for Cisco IMC 2.0(13) or later firmware. This is used to upgrade
the system to Cisco S3260 with M4 server node requirements.
For instructions on downloading and using the utility, see the instructions in the guide for your
release:
HUU Guides
After the upgrade, you must manually define drive zoning to map the hard drives to individual server
nodes.
After the upgrade, your boot SSDs might lose their operating system. In this case, reinstall your
operating system to the boot SSDs.
Ensure that the entire C3160 system is running Cisco IMC 2.0(8) or 2.0(9).
Upgrade the entire C3160 system to 2.0(13).
Disconnect all power cords to remove power from the system.
Replace the C3160 SIOCs with S3260 SIOCs (
Replace the M3 server node with an M4 server node.
Reconnect network cables and power cords.
Boot the system and set CMC and BMC to factory defaults.
Configure IP addresses and network settings.
Perform drive zoning for hard drives.
Appendix E
Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes
UCSC-S3260-SIOC.
for more information.
UCSC-S3260-SIOC)
This new SIOC must be running
.

Advertisement

Table of Contents
loading

Table of Contents