Cisco UCS S3260 Service Manual page 114

Older Migration and Upgrade Procedures
If your system has rear panel SSDs, ensure that they are in the correct SSD bays to communicate with
Step 7
the M4 server node that you just installed:
If your single server node is in server bay 1 (see
•
can be used.
If your single server node is in server bay 2, only Server 2 bays SSD1 and SSD2 can be used.
•
Figure E-2
40-Gb QSFP ports (two on each SIOC)
1
10/100/1000 dedicated management port
2
Reconnect power cables to the system. Wait for approximately five minutes to allow the system to boot
Step 8
up.
Connect a KVM cable (Cisco PID N20-BKVM) to the KVM connector on the server node at the rear of
Step 9
the system (see
Open the Cisco IMC Configuration Utility:
Step 10
Press and hold the front panel power button for four seconds to boot the system. Watch the screen
a.
for the prompt to press F8.
During bootup, press F8 when prompted to open the Cisco IMC Configuration Utility.
b.
This utility has three windows that you can toggle between by pressing F1 or F2.
The utility prompts you to change the default user password. Set a default user password before
Step 11
continuing.
Set the CMCs in all SIOCs and the BMCs in all server nodes to the factory defaults.
Step 12
The Factory Default check box has two options but you must perform two resets in this order:
Select Chassis Controller Configuration and save your changes. Both CMCs in the SIOCs are set
a.
to the factory default state.
Select Server Controller Configuration and save your changes. The server node is set back to its
b.
factory default state and the server/host reboots.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
E-20
Appendix E
Rear Panel Connectors for Setup
Figure E-3). Connect a USB keyboard and a VGA monitor to the KVM cable.
Upgrading to Cisco UCS S3260 System With S3260 M5 Server Nodes
Figure E-2), only Server 1 bays SSD1 and SSD2
3 KVM console connector on each server node