Cisco UCS S3260 Service Manual page 66

Installing or Replacing System Components
Using the Cisco IMC PMCLI Interface to Update SIOC Adapter Firmware
Update and activate the adapter firmware by using the following commands:
Step 1
Server# scope chassis
Server/chassis# update-adapter-fw <protocol> <remote server IP address> <image file path>
<activate|no-activate> [SIOC slot number]
For example:
server1/chassis# update-adapter-fw tftp nnn.nnn.nnn.nnn /fw-image.bin activate 1
Adapter firmware update has started. Please check the status using "show adapter detail".
You have chosen to automatically activate the new firmware image. Please reset your
adapter after the update finishes.
Reset the adapter:
Step 2
Note
server/chassis# adapter-reset <SIOC1 or SIOC2>
For example:
server/chassis# adapter-reset SIOC1
The adapter and host reset. The activated firmware becomes the running version.
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
3-32
The adapter and host reset. The activated firmware becomes the running version.
You must reset the adapter to make the activated firmware version the running version. Resetting
the adapter also causes the host to reset.
Chapter 3 Maintaining the System