Advertisement
This product requires short-circuit (overcurrent) protection, to be provided as part of the
Warning
building installation. Install only in accordance with national and local
wiring regulations.
Care must be given to connecting units to the supply circuit so that wiring is
Warning
not overloaded.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do
not directly touch the backplane with your hand or any metal tool, or you could
shock yourself.
Installing the Cisco 6100 Thermal Upgrade Kit
The following sections detail the installation procedures for upgrading your Cisco 6100 chassis to
accommodate dual-port DMT-2 or quad-port flexi ATU-C modules.
Only trained and qualified personnel should be allowed to install, replace, or service
Warning
this equipment.
Before installing and cabling the equipment, be aware of standard safety practices and the
Note
hazards involved in working with electrical circuitry to prevent accidents. See the
"General Safety Precautions" section on page 6 for all cautions and warnings necessary to
ensure a safe and hazard-free installation.
To see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information for the Cisco 6100 Series System document.
78-10158-01
Installing the Cisco 6100 Thermal Upgrade Kit
Cisco 6100 Thermal Upgrade Kit Installation Procedures
9
Advertisement
