Configuring Zone Generic Service Permission Settings; Displaying Enhanced Zone Information - Cisco MDS 9000 Series Configuration Manual

Configuring and Managing Zones
Configures permit as the default zoning policy for new VSANs on the switch.
Step 3
switch(config)# system default zone distribute full
Enables full zone database distribution as the default for new VSANs on the switch.
Step 4
switch(config)# system default zone gs {read | read-write}
Configures read only or read-write (default) as the default generic service permission for new VSANs on the switch.
Note Since VSAN 1 is the default VSAN and is always present on the switch, the system default zone commands
have no effect on VSAN 1.

Configuring Zone Generic Service Permission Settings

Zone generic service permission setting is used to control zoning operation through generic service (GS)
interface. The zone generic service permission can be read-only, read-write or none (deny).
To configure generic service (GS) settings, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# zone gs {read | read-write}vsan 3000
Configures gs permission value as read only or read-write in the specified VSAN.

Displaying Enhanced Zone Information

You can view any zone information by using the show command.
Displays the Active Zoneset Information for a Specified VSAN
switch(config)# show zoneset active vsan 1
zoneset name qoscfg vsan 1
zone name qos1 vsan 1
* fcid 0xe80200 [pwwn 50:08:01:60:01:5d:51:11]
* fcid 0xe60000 [pwwn 50:08:01:60:01:5d:51:10]
* fcid 0xe80100 [pwwn 50:08:01:60:01:5d:51:13]
zone name qos3 vsan 1
* fcid 0xe80200 [pwwn 50:08:01:60:01:5d:51:11]
* fcid 0xe60100 [pwwn 50:08:01:60:01:5d:51:12]
* fcid 0xe80100 [pwwn 50:08:01:60:01:5d:51:13]
zone name sb1 vsan 1
* fcid 0xe80000 [pwwn 20:0e:00:11:0d:10:dc:00]
* fcid 0xe80300 [pwwn 20:0d:00:11:0d:10:da:00]
* fcid 0xe60200 [pwwn 20:13:00:11:0d:15:75:00]
* fcid 0xe60300 [pwwn 20:0d:00:11:0d:10:db:00]
Configuring Zone Generic Service Permission Settings
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
131