Configuring Fspf On A Vsan; Resetting Fspf To The Default Configuration; Enabling Or Disabling Fspf - Cisco MDS 9000 Series Configuration Manual

Configuring Fibre Channel Routing Services and Protocols

Configuring FSPF on a VSAN

To configure an FSPF feature for the entire VSAN, follow these steps:
Step 1 switch# config terminal
switch(config)#
Enters configuration mode.
Step 2 switch(config)# fspf config vsan 1
Enters FSPF global configuration mode for the specified VSAN.
Step 3 switch-config-(fspf-config)# spf static
Forces static SPF computation for the dynamic (default) incremental VSAN.
Step 4
switch-config-(fspf-config)# spf hold-time 10
Configures the hold time between two route computations in milliseconds (msec) for the entire VSAN. The default value
is 0.
Note If the specified time is shorter, the routing is faster. However, the processor consumption increases accordingly.
Step 5
switch-config-(fspf-config)# region 7
Configures the autonomous region for this VSAN and specifies the region ID (7).

Resetting FSPF to the Default Configuration

To return the FSPF VSAN global configuration to its factory default, follow these steps:
Step 1
switch# config terminal
switch(config)#
Enters configuration mode.
Step 2 switch(config)# no fspf config vsan 3
Deletes the FSPF configuration for VSAN 3.

Enabling or Disabling FSPF

To enable or disable FSPF routing protocols, follow these steps:
Step 1 switch# config terminal
switch(config)#
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
Configuring FSPF on a VSAN
189