Cisco MDS 9000 Series Configuration Manual page 227

Configuring Fibre Channel Routing Services and Protocols
Table 20: Default FSPF Settings
Parameters
FSPF
SPF computation
SPF hold time
Backbone region
Acknowledgment interval (RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
Hello interval
Dead interval
Distribution tree information
Routing table
Load balancing
In-order delivery
Drop latency
Static route cost
Remote destination switch
Multicast routing
Default
Enabled on all E ports and TE ports.
Dynamic.
0.
0.
5 seconds.
30 minutes.
60 minutes.
20 seconds.
80 seconds.
Derived from the principal switch (root node).
FSPF stores up to 16 equal cost paths to a given destination.
Based on destination ID and source ID on different, equal cost
paths.
Disabled.
Disabled.
If the cost (metric) of the route is not specified, the default is 10.
If the remote destination switch is not specified, the default is
direct.
Uses the principal switch to compute the multicast tree.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
Default Settings
205