Clearing Fspf Counters For The Vsan; Fspf Interface Configuration; About Fspf Link Cost; Configuring Fspf Link Cost - Cisco MDS 9000 Series Configuration Manual

Clearing FSPF Counters for the VSAN

Enters configuration mode.
Step 2
switch(config)# fspf enable vsan 7
Enables the FSPF routing protocol in VSAN 7.
Step 3
switch(config)# no fspf enable vsan 5
Disables the FSPF routing protocol in VSAN 5.
Clearing FSPF Counters for the VSAN
To clear the FSPF statistics counters for the entire VSAN, follow this step:
switch# clear fspf counters vsan 1
Clears the FSPF statistics counters for the specified VSAN. If an interface reference is not specified, all counters are
cleared.

FSPF Interface Configuration

Several FSPF commands are available on a per-interface basis. These configuration procedures apply to an
interface in a specific VSAN.
This section includes the following topics:

About FSPF Link Cost

FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database, and
then chooses the path with a minimal cost. The cost associated with an interface can be administratively
changed to implement the FSPF route selection. The integer value to specify cost can range from 1 to 30000.
The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.

Configuring FSPF Link Cost

To configure FSPF link cost, follow these steps:
Step 1
switch# config t
switch(config)#
Enters configuration mode.
Step 2 switch(config)# interface fc1/4
switch(config-if)#
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
190
Configuring Fibre Channel Routing Services and Protocols