Cisco MDS 9000 Series Configuration Manual page 64

Using the Quick Config Wizard
To add or remove ports from a zone and to zone only the devices within a specific VSAN using Device
Manager on the Cisco MDS 9124 Switch, follow these steps:
Step 1 Choose FC > Quick Config or click the Zone icon in the toolbar.
You see the Quick Config Wizard (see
Discrepancies dialog box (see
configurations.
You will see the Discrepancies dialog box only if there are any discrepancies.
Note
Figure 7: Discrepancies Dialog Box
Step 2 Click OK to continue.
You see the Quick Config Wizard dialog box (see
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
42
Figure 8: Quick Config Wizard, on page
Figure 7: Discrepancies Dialog Box, on page
Figure 8: Quick Config Wizard, on page
Configuring and Managing Zones
43) with all controls disabled and the
42), which shows all unsupported
43).