Honeywell Thor VM3 User Manual page 270

Roaming
The Roaming tab is used to configure roaming behavior.
Roam
Signal Level (dBm)
Logging Enable
Minimum Connection
Time (sec)
Roam RISSI Difference
(dBm)
Background Scan
Signal Level (dBm)
Probe Request Interval
(sec)
CCX Control
258
When the signal strength is below this level, the radio will attempt to roam.
Default -65 dBm, range is -80 to -55.
When checked, logging is enabled. Logging can be set to Critical (fewer
messages) or All (more messages). Logging is disabled by default.
Note: Logging is set to disabled after any reboot to prevent log files for
taking up disk space when not needed.
The minimum connection time the radio stays connected to the current
access point before roaming begins. Default 10 seconds, range is 5 to 25.
The minimum signal strength difference between APs before the radio
roams. Default 5 dBm, range is 5 to 25.
The minimum signal strength an access point signal must have to be
considered for roaming. Default -65 dBm, range is -80 to -55.
The interval between roam probes. Default 5 seconds, range is 5 to 60.
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide