Cisco TelePresence MX700 and MX800
Introduction
Call commands
xCommand Call Accept
Accept an incoming call. If no CallId is specified, all incoming calls are accepted.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Accept [CallId: CallId]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId. The default is set to 0.
xCommand Call Disconnect
Disconnect a call.
Requires user role: ADMIN,INTEGRATOR, USER
USAGE:
xCommand Call Disconnect [CallId: CallId]
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId. The default is set to 0.
D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
About the API
xConfiguration
xCommand
xCommand
xCommand Call DTMFSend
Send DTMF tones to the far end.
Requires user role: ADMIN, USER
USAGE:
xCommand Call DTMFSend [CallId: CallId] DTMFString: "DTMFString"
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId. The default is set to -1.
DTMFString: String (0, 32)
Enter the DTMF string.
xCommand Call FarEndControl Camera Move
Move the far end camera (the remote camera).
NOTE: The far end camera moves in the specified direction until the stop command (ref:
xCommand FarEndControl Camera Stop) is issued.
Requires user role: ADMIN, USER
USAGE:
xCommand Call FarEndControl Camera Move [CallId: CallId] Value:
where
CallId: Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId. The default is set to -1.
Value: Left/Right/Up/Down/ZoomIn/ZoomOut
Select the action for how to move the camera.
118
API Reference Guide
xStatus
Appendices
Value
Copyright © 2017 Cisco Systems, Inc. All rights reserved.