Connect Cables; Strain Relief Cable Clamps - Honeywell Thor VM2 User Manual

Connect Cables

There are many cables available for the Thor VM2 including power cables, and data/ communication cables.

Strain Relief Cable Clamps

Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the Thor VM2 dock.
Use the left-most strain relief clamp for the power cable.
To use the strain relief clamp(s):
1. Determine the proper strain relief cable clamp. There are three sizes of cable clamps on the dock which should be
matched to the cable to be secured. For example, the largest clamp (on the left when viewing the back of the dock) is
designed to secure the power cable.
2. Remove the strain relief clamp from the Thor VM2 by turning the screw counterclockwise. Put the screw aside in a safe
location.
3. Slide the strain relief clamp over the cable.
4. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the Dock. Do not
stretch the cable. Leave enough slack in the cable to allow it to be connected and disconnected easily when needed.
5. Continue in this manner until all cables are secured to the dock.
4 - 16