Wpa Psk - Honeywell Thor VM2 User Manual

WPA PSK

To connect using WPA/PSK, make sure the following profile options are used:
1. Enter the SSID of the Access Point assigned to this profile
2. Set Auth Type to Open
3. Set WPA as follows:
• Select WPA/WPA2 to use either TKIP/AES or AES-CCMP
• Select WPA2 to use AEX-CCMP
4. Set Encryption to either TKIP/AES or AES-CCMP depending on WPA type selected
5. Set Authentication to PSK
Click the WEP keys/PSKs button.
This value can be 64 hex characters or an 8 to 63 byte ASCII value. Enter the key and click OK.
Once configured, click the Commit button.
Ensure the correct Active Profile is selected on the Configuration tab and restart. The Status tab shows the device is
connected.
6 - 34