Honeywell Thor VM2 User Manual page 120

AC/DC
Select the AC/DC power scheme/plan when manual control of the Thor VM2 power on process is desired.
This is the default power scheme/plan. In AC/DC mode the Thor VM2 is turned on by a press of the Power button.
Ignition input is ignored when AC/DC Mode is enabled.
The following default timeouts are used in the AC/DC power scheme/plan.
Windows Embedded Standard 2009
Setting
Turn off monitor
Turn of hard disks
System standby
System hibernate
Windows Embedded Standard 7, Windows 7 Professional
Setting
Dim the display
Turn of the display
Put the computer to sleep
Hibernate after
Note: By default Sleep is disabled and Hibernate is enabled. Because the Thor VM2 with Windows Embedded
Standard 7 or Windows 7 Professional cannot transition from Sleep to Hibernate due to a limitation of the
operating system, Sleep is disabled. Power savings are significantly greater using Hibernate.
Note: When the Thor VM2 has a Windows 7 operating system and a 32 GB SSD drive the files necessary for
hibernate may result in low disk space if installed applications or data are using large amounts of hard drive
space.
5 - 22
Plugged In
(AC or DC Power)
30 minutes
30 minutes
5 hours
Never
Plugged In
(AC or DC Power)
Never
30 minutes
Never (see note)
300 minutes
Running on Batteries
(UPS Power)
1 minute
1 minute
10 minutes
20 minutes
On Battery
(UPS Power)
Never
1 minute
Never (see note)
20 minutes