Honeywell Thor VM2 User Manual page 122

Ignition Control/Ignition On
Select either the Ignition Control/Ignition On or the Ignition Control/Ignition Off power scheme/plan when ignition
control of the Thor VM2 power on process is desired.
The Thor VM2 aromatically switches between the Ignition Control/Ignition On or the Ignition Control/Ignition Off
power schemes/plans depending on the state of the vehicle ignition input.
The following default timeouts are used in the Ignition Control/Ignition On power scheme./plan
Setting
Turn off monitor
Turn of hard disks
System standby/sleep
System hibernate
Windows Embedded Standard 7, Windows 7 Professional
Setting
Dim the display
Turn of the display
Put the computer to sleep
Hibernate after
Note: By default Sleep is disabled and Hibernate is enabled. Because the Thor VM2 with Windows Embedded
Standard 7 or Windows 7 Professional cannot transition from Sleep to Hibernate due to a limitation of the
operating system, Sleep is disabled. Power savings are significantly greater using Hibernate.
Note: When the Thor VM2 has a Windows 7 operating system and a 32 GB SSD drive the files necessary for
hibernate may result in low disk space if installed applications or data are using large amounts of hard drive
space.
The ignition input wire must be connected. If the user selects this power scheme/plan but the ignition is Off, the
Ignition Control/Ignition Off scheme/plan is used instead.
5 - 24
Plugged In
(AC or DC
Power)
30 minutes
30 minutes
5 hours
Never
Plugged In
(AC or DC Power)
Never
30 minutes
Never (see note)
300 minutes
Running on
Batteries
(UPS Power)
1 minute
1 minute
10 minutes
20 minutes
On Battery
(UPS Power)
Never
1 minute
Never (see note)
20 minutes