Cisco-Switch - Cisco Catalyst 4500 Series Software Configuration Manual

Cisco ios xe release 3.9.xe and cisco ios release 15.2(5)ex
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 21
Configuring SmartPort Macros
switchport port-security aging type inactivity
# Enable auto-qos to extend trust to attached Cisco phone
auto qos voip cisco-phone
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable@
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------

cisco-switch

This example shows how to use the system-defined macro cisco-switch to assign a value of 38 to the
native VLAN on the Fast Ethernet interface 2/9.
This macro requires the $NVID keyword, which is the native VLANs of the port.
Note
Switch(config)# interface fastethernet2/9
Switch(config-if)# macro apply cisco-switch
Switch(config-if)# macro description cisco-switch $NVID 38
Switch(config-if)# end
Switch# show parser macro name cisco-switch
Macro name : cisco-switch
Macro type : customizable
# Access Uplink to Distribution
switchport trunk encapsulation dot1q
# Define unique Native VLAN on trunk ports
# Recommended value for native vlan (NVID) should not be 1
switchport trunk native vlan $NVID [native_vlan_id]
# Update the allowed VLAN range (VRANGE) such that it
# includes data, voice and native VLANs
# switchport trunk allowed vlan $VRANGE [vlan_range]
# Hardcode trunk and disable negotiation to
# speed up convergence
switchport mode trunk
switchport nonegotiate
# Configure qos to trust this interface
auto qos voip trust
# 802.1w defines the link as pt-pt for rapid convergence
spanning-tree link-type point-to-point
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------
cisco-router
This example shows how to use the system-defined macro cisco-router to assign a value of 451 to the
native VLAN on the Fast Ethernet interface 2/9.
Note
This macro requires the $NVID keyword, which is the native VLANs of the port.
Macro Description
cisco-phone
Macro Description
cisco-switch
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Configuring SmartPort Macros
21-11

Advertisement

Table of Contents
loading

Table of Contents