Configuring Eigrp Stub Routing - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 35 Configuring Layer 3 Interfaces
Command
Step 7
Switch# copy running-config startup-config
Step 8
Switch# show interfaces [type slot/interface]
Switch# show ip interfaces [type slot/interface]
Switch# show running-config interfaces [type
slot/interface]
This example shows how to configure an IP address on Fast Ethernet interface 2/1:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# ip routing
Switch(config)# interface fastethernet 2/1
Switch(config-if)# no switchport
Switch(config-if)# ip address 10.1.1.1 255.255.255.248
Switch(config-if)# no shutdown
Switch(config-if)# end
Switch#
This example shows how to use the show running-config command to display the interface IP address
configuration of Fast Ethernet interface 2/1:
Switch# show running-config
Building configuration...
!
interface FastEthernet2/1
no switchport
ip address 10.1.1.1 255.255.255.248
!
...
ip classless
no ip http server
!
!
line con 0
line aux 0
line vty 0 4
!
end

Configuring EIGRP Stub Routing

This section consists of the following subsections:
•
•
•
•
About EIGRP Stub Routing
The EIGRP stub routing feature, available in all images, reduces resource utilization by moving routed
traffic closer to the end user.
About EIGRP Stub Routing, page 35-13
Configuring EIGRP Stub Routing, page 35-14
Monitoring and Maintaining EIGRP, page 35-19
EIGRP Configuration Examples, page 35-20
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Saves your configuration changes to NVRAM.
Verifies the configuration.
End with CNTL/Z.
Configuring EIGRP Stub Routing
35-13