Cisco Catalyst 4500 Series Software Configuration Manual page 950

Chapter 35 Configuring Layer 3 Interfaces
Configuring EIGRP Stub Routing
other optional keywords (connected, static, and summary) can be used in any combination but cannot
be used with the receive-only keyword. If any of these three keywords is used individually with the eigrp
stub command, connected and summary routes are not sent automatically.
The connected keyword permits the EIGRP stub routing feature to send connected routes. If the
connected routes are not covered by a network statement, it may be necessary to redistribute connected
routes with the redistribute connected command under the EIGRP process. This option is enabled by
default.
The static keyword permits the EIGRP stub routing feature to send static routes. Without the static
keyword, EIGRP does not send any static routes, including internal static routes that normally are
automatically redistributed. It is still necessary to redistribute static routes with the redistribute static
command.
The summary keyword permits the EIGRP stub routing feature to send summary routes. Summary
routes can be created manually with the summary address command or automatically at a major
network border router with the auto-summary command enabled. This option is enabled by default.
In the following example, the eigrp stub command is used to configure the router as a stub that
advertises connected and summary routes:
router eigrp 1
network 10.0.0.0
eigrp stub
In the following example, the eigrp stub connected static command is used to configure the router as a
stub that advertises connected and static routes (sending summary routes is not permitted):
router eigrp 1
network 10.0.0.0
eigrp stub connected static
In the following example, the eigrp stub receive-only command is used to configure the router as a stub,
and connected, summary, or static routes is not sent:
router eigrp 1
network 10.0.0.0 eigrp
stub receive-only
In the following example, the eigrp stub redistributed command is used to configure the router as a
stub that advertises redistributed routes (sending connected, static, or summary routes is not permitted):
router eigrp 1
network 10.0.0.0
eigrp stub redistributed
In the following example, the eigrp stub command is used to configure the router as a stub that
advertises redistributed, static, connected and summary routes:
router eigrp 1
network 10.0.0.0
eigrp stub connected static summary redistributed
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
35-22