Configuring Rep Interfaces - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring REP

Configuring REP Interfaces

For REP operation, you need to enable it on each segment interface and identify the segment ID. This
step is required and must be done before other REP configuration. You must also configure a primary
and secondary edge port on each segment. All other steps are optional.
To enable and configure REP on an interface, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface interface-id
Step 3
Switch(config-if)# switchport mode trunk
or,
switchport mode private-vlan trunk
promiscuous
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
25-10
Chapter 25
Purpose
Enters global configuration mode.
Specifies the interface, and enter interface configuration mode. The
interface can be a physical Layer 2 interface or a port channel
(logical interface). The port-channel range is 1 to 48.
Configures the Layer 2 interface as a Layer 2 trunk port.
Configures the Layer 2 interface as a PVLAN promiscuous trunk
port.
For information on command options for PVLAN promiscuous trunk
ports, refer to "Configuring a Layer 2 Interface as a Promiscuous
PVLAN Trunk Port" on page 21.
With REP, only the switchport mode private-vlan trunk
Note
promiscuous command is supported; other PVLAN trunk
related configurations are not supported.
Configuring Resilient Ethernet Protocol