Cisco Catalyst 4500 Series Software Configuration Manual page 339

Chapter 6 Programmability
Startup Configuration Errors
If you encounter errors when you replace the existing startup configuration with a new configuration,
the system does not replace the existing startup configuration. You must resolve the errors in the switch
start-up configuration file before resuming.
Debugging the DMI
To start debugging the DMI container, perform the following task:
Set the logging level to "debug" in cisco-ia.yang model.
Step 1
In the privilege EXEC Mode on the switch CLI, enter one of these commands and use NETCONF to read
Step 2
the responses
–
–
To display NETCONF statistical information, such as, the number of sessions, netconf RPCs, packets
Step 3
and so on, use the ietf-netconf-monitoring.yang model.
The following is sample output for the show remotemanagement command confd log command:
Switch# show remotemanagement dmi confd log
remotemanagement-iosxe-remote-mgmt-8086
******************************* cia-confd.log ********************************
<DEBUG> 16-Nov-2016::22:58:44.010 iosxe-remote-mgmt confd[28320]: - Loading file
./mib-fxs/VPN-TC-STD-MIB.fxs
<DEBUG> 16-Nov-2016::22:58:44.018 iosxe-remote-mgmt confd[28320]: - Loading file
./mib-fxs/IANA-ADDRESS-FAMILY-NUMBERS-MIB.fxs
<DEBUG> 16-Nov-2016::22:58:44.019 iosxe-remote-mgmt confd[28320]: - Loading file
./mib-fxs/IANA-RTPROTO-MIB.fxs
<DEBUG> 16-Nov-2016::22:58:44.020 iosxe-remote-mgmt confd[28320]: - Loading file
./mib-fxs/IEEE8021-TC-MIB.fxs
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
export@cisco.com.
cisco WS-C4500X-16 (MPC8572) processor (revision 3) with 4194304K bytes of
physical memory.
Processor board ID JAE155209ZG
MPC8572 CPU at 1.5GHz, Cisco Catalyst 4500X
Last reset from Reload
1 Virtual Ethernet interface
16 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Press RETURN to get started!
Switch>
The debug remotemanagement command.
The show remotemanagement command
Troubleshooting Programmability
6-27