Converting The Vss Standby Switch To Standalone - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring a VSS
We do not recommend that you convert a VSS to standalone in a live network.

Converting the VSS Standby Switch to Standalone

When you convert the new VSS Active switch to standalone mode, the switch removes the provisioning
and configuration information related to VSL links and the peer switch modules, saves the configuration
file and performs a reload. The switch comes up in standalone mode with only its own provisioning and
configuration data.
To convert the peer switch to standalone, perform this task on the VSS Standby switch:
Command
Switch-2# switch convert mode stand-alone
Configuring VSS Parameters
These sections describe how to configure VSS parameters:
•
•
•
•
•
•
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
5-42
Configuring VSL Switch Priority, page 5-43
Configuring a VSL, page 5-44
Adding and Deleting a VSL Port After the Bootup, page 5-44
Displaying VSL Information, page 5-45
Configuring VSL QoS, page 5-46
Configuring the Router MAC Address, page 5-47
Chapter 5 Configuring Virtual Switching Systems
Purpose
Converts Switch 2 to standalone mode.
After you enter the command, you are prompted to
confirm the action. Enter yes.