Configuring Programmability Components - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring Programmability Components

Configuring Programmability Components
You can use Zero-Touch Provisioning to configure the programmability components or follow the
standard configuration method (by configuring all required tasks individually).
The following applies to both methods of configuration:
•
•
For zero touch provisioning, you must ensure that you have met:
•
For the standard configuration method, you must complete the following:
•
•
•
•
•
Prerequisites for Configuring Programmability
•
•
•
Note
Note
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
6-4
Prerequisites for Configuring Programmability, page 6-4
Restrictions and Limitations for Configuring Programmability, page 6-5
Zero-Touch Provisioning Requirements, page 6-5
Installing and Activating the DMI Container, page 6-9
Configuring One Platform Kit (OnePK), page 6-10
Providing Privilege Access to Use NETCONF and RESTCONF, page 6-11
Enabling the NETCONF Interface, page 6-12
Enabling Cisco IOS HTTP Services for RESTCONF, page 6-13
Prerequisites for NETCONF and RESTCONF:
Your access to the switch is configured with privilege level 15. This is required to start working with
NETCONF and RESTCONF interfaces. See
RESTCONF, page 6-11.
To use the programmability feature, you must use the Universal Crypto Image. See section
"Orderable Product Numbers" in the corresponding release notes:
Release Notes for the Catalyst 4500-X Series Switches
–
Release Notes for the Catalyst 4500-E Series
–
Prerequisites for using PXE boot:
– The boot capability is set to autoboot and the bootfield is set to 04, 05, or 06. PXE boot is
supported only if you have enabled autoboot.
For PXE boot, the boot capability is set to autoboot by default.
The required ROMMON version is installed:
–
On Catalyst 4500-X Series Switches, ROMMON version 15.0(1r)SG14 applies.
On Catalyst 4500-E Series Switches, ROMMON version 15.1(1r)SG8 applies.
With the above ROMMON versions, the factory default setting for the configuration register
value is 0x2106 (boot field 06). This is also the recommended setting if you are using an existing
device and upgrading to these ROMMON versions.
If you are not using PXE boot, you do not have to upgrade the ROMMON version.
Providing Privilege Access to Use NETCONF and
Chapter 6 Programmability