Cisco Catalyst 4500 Series Software Configuration Manual page 640

VLAN Membership Policy Server
Configuring Reconfirmation Interval
VMPS clients periodically reconfirm the VLAN membership information received from the VMPS. You
can set the number of minutes the VMPS client waits before reconfirming the VLAN-to-MAC-address
assignments.
To configure the reconfirmation interval, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# vmps reconfirm minutes
Step 3
Switch(config)# end
Step 4
Switch# show vmps
This example shows how to change the reconfirmation interval to 60 minutes and verify the change:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps reconfirm 60
Switch(config)# end
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version:
Reconfirm Interval: 60 min
Server Retry Count: 10
VMPS domain server: 172.20.130.50 (primary, current)
Reconfirmation status
---------------------
VMPS Action:
Configuring the Retry Interval
You can set the number of times that the VMPS client attempts to contact the VMPS before querying the
next server.
To configure the retry interval, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# vmps retry count
Step 3
Switch(config)# end
Step 4
Switch# show vmps
This example shows how to change the retry count to 5 and to verify the change:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps retry 5
Switch(config)# end
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
17-26
Purpose
Enters global configuration mode.
Specifies the number of minutes between reconfirmations of the
dynamic VLAN membership.
Returns to privileged EXEC mode.
Verifies the dynamic VLAN reconfirmation status.
1
No Host
Purpose
Enters global configuration mode.
Specifies the retry count for the VPQ queries. Default is 3. Range is
from 1 to 10.
Returns to privileged EXEC mode.
Verifies the retry count.
Chapter 17 Configuring VLANs, VTP, and VMPS