Redundant Supervisor Mode - Cisco Catalyst 4500 Series Software Configuration Manual

Table 9-5
Supervisor Engine Uplink Ports
A1
Choose 10-Gigabit operation through the command line interface.
SFP+
SFP+
SFP+ and SFP can be inserted in any order for lines 2 to 4.

Redundant Supervisor Mode

In redundant supervisor mode, WS-X45-SUP-7L-E supports 1+1 (in 10-Gigabit mode) and 2+2 (in 1-Gigabit mode)
(Table 9-6).
Table 9-6
Active Supervisor Uplink
Ports
A1
Choose 10-Gigabit operation through the command line interface.
SFP+
SFP+
SFP
SFP
Digital Optical Monitoring Transceiver Support
Command line interface (CLI) commands (show inventory, show idprom interface) are used on transceivers to obtain serial
number, model name, inventory information.
The following commands are specific to the transceivers that support the DOM capability:
Displays current values and thresholds for all sensor on a particular interface transceiver:
•
show interfaces int-name transceiver [detail] [threshold]
• Enables or disables the entSensorThresholdNotification for all sensors in all the transceivers:
snmp-server enable trap transceiver
• Enables or disables transceiver monitoring:
transceiver type all
monitoring
Digital Optical Monitoring Transceiver Support
Uplink Options for Single Supervisor Mode
A2
SFP+
SFP
Uplink Options for Redundant Supervisor Mode
A2 A3 A4
— —
— —
— —
SFP — —
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
9
Speeds Achievable with the Following Combination of
Pluggables (Band Width)
20 Gbps
11 Gbps
Standby Supervisor Uplink
Ports
B1 B2 B3 B4
SFP+ — —
SFP — —
SFP+ — —
SFP SFP — —
Chapter 9 Configuring Interfaces
Speeds Achievable with this
Combination of Pluggables
20 Gbps
11 Gbps
11 Gbps
4 Gbps