IEEE 802.3az Energy Efficient Ethernet
For more details, see the URL:
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps4324/white_paper_c11-676336.pdf
Sections include:
•
•
•
Determining EEE Capability
To determine whether a line card supports EEE, use the show interface capabilities module module
command, as follows:
Switch# show interface capabilities module 3
GigabitEthernet3/1
Model:
Type:
Speed:
Duplex:
Auto-MDIX:
EEE:
Enabling EEE
To enable EEE on a given port, use the power efficient-ethernet auto command.
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface interface
Step 3
Switch(config-if)# power efficient-ethernet auto
Step 4
Switch(config-if)# exit
The following example shows how to enable EEE:
Switch# config t
Switch(config)# interface gigabitethernet 1/1
Switch(config-if)# power efficient-ethernet auto
Switch(config-if)# exit
Determining EEE Status
To determine EEE status use the show platform software interface interface status command:
The following example determines EEE status:
Switch(config)# show platform software interface g2/1 status
Switch Phyport Gi2/1 Software Status
EEE: Disabled
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
14-24
Determining EEE Capability, page 14-24
Enabling EEE, page 14-24
Determining EEE Status, page 14-24
WS-X4748-NGPOE+E-RJ-45
10/100/1000-TX
10,100,1000,auto
half,full,auto
yes
yes ( 100-Tx and 1000-T auto mode )
Chapter 14
Environmental Monitoring and Power Management
Purpose
Enters configuration mode.
Enters interface configuration mode and
specifies the port to be configured.
Enables EEE.
Exits global configuration mode.