Configuring Interfaces - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring Interfaces

This chapter describes how to configure interfaces for the standalone and modular Catalyst 4500 series switches. It also
provides guidelines, procedures, and configuration examples.
This chapter includes the following major sections:
About Interface Configuration, page 9-2
•
Using the interface Command, page 9-2
•
Configuring a Range of Interfaces, page 9-4
•
Using the Ethernet Management Port, page 9-5
•
• Defining and Using Interface-Range Macros, page 9-10
• Deploying SFP+ in X2 Ports, page 9-11
• Deploying 10-Gigabit Ethernet and Gigabit Ethernet SFP Ports on Supervisor Engine V-10GE, page 9-12
Deploying 10-Gigabit Ethernet or Gigabit Ethernet Ports, page 9-13
•
Configuring MultiGigabit Ports on WS-X4748-12X48U+E, page 9-15
•
Invoking Shared-Backplane Uplink Mode on Supervisor Engine 6-E and Supervisor Engine 6L-E, page 9-19
•
Limitation and Restrictions on Supervisor Engine 7-E and Supervisor Engine 7L-E, page 9-20
•
Selecting Uplink Mode on a Supervisor Engine 6-E, page 9-20
•
Selecting the Uplink Port on a Supervisor Engine 7L-E, page 9-25
•
Digital Optical Monitoring Transceiver Support, page 9-26
•
Configuring Optional Interface Features, page 9-27
•
Understanding Online Insertion and Removal, page 9-41
•
Online Insertion and Removal on a WS-4500X-32, page 9-41
•
• Monitoring and Maintaining the Interface, page 9-44
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
9
C H A P T E R
Releases.
Switch.