Manipulating Bootflash On The Redundant Supervisor Engine - Cisco 4500M Software Manual

Manipulating Bootflash on the Redundant Supervisor Engine

Manipulating Bootflash on the Redundant Supervisor Engine
Note
To manipulate the redundant supervisor engine bootflash, perform one or more of the following tasks:
Command
Switch# dir slaveslot0: target_filename
Or:
Switch# dir slavebootflash: target_filename
Switch# delete slaveslot0: target_filename
Or:
Switch# delete slave bootflash: target_filename
Switch# squeeze slaveslot0: target_filename
Or:
Switch# squeeze slavebootflash: target_filename
Switch# format slaveslot0: target_filename
Or:
Switch# format slavebootflash: target_filename
Switch# copy source_device : source_filename
slaveslot0: target_filename
Or:
Switch# copy source_device : source_filename
slavebootflash: target_filename
Software Configuration Guide—Release 12.2(25)EW
6-14
The console port on the redundant supervisor engine is not available.
Chapter 6 Configuring Supervisor Engine Redundancy Using RPR and SSO
Purpose
Lists the contents of the slot0: device on the redundant
supervisor engine.
Lists the contents of the bootflash: device on the redundant
supervisor engine.
Deletes specific files from the slot0: device on the redundant
supervisor engine.
Deletes specific files from the bootflash: device on the
redundant supervisor engine.
Squeezes the slot0: device on the redundant supervisor
engine.
Squeezes the bootflash: device on the redundant supervisor
engine.
Formats the slot0: device on the redundant supervisor engine.
Formats the bootflash: device on the redundant supervisor
engine.
Copies a file from the active supervisor engine to the slot0:
device on the redundant supervisor engine.
Copies a file to the bootflash: device on a redundant
supervisor engine.
Source could be the active supervisor engine or a TFTP server.
Note
OL-6696-01