Cisco 500 series Administration Manual page 88
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
General Administrative Information
TCAM Allocation
STEP 3
STEP 4
Cisco 500 Series Stackable Managed Switch Administration Guide
You must save your current configuration before changing the TCAM Allocation
Settings.
Enter the New Settings, which must follow the rules below:
•
For the Max Number of IPv4 Static Routes, the new value must be greater
than or equal to the current used.
•
For the Max Number of IP Interfaces, the new value must be greater than or
equal to the current used.
•
New Max Number of IPv4 Static Routes + 2*Max Number of IP Interfaces +
Max Number of IP Host <= Total number of TCAM entries - Total number of
non-IP entries used.
The available number of non-IP entries after your change has been made is
displayed.
Save the new settings by clicking Save. This checks the feasibility of the TCAM
allocation. If it is incorrect, an error message is displayed. If it is correct, the
allocation is copied to the Running Configuration file.
Click Apply and an automatic reboot is performed using the new settings.
TCAM Allocation Page
To view TCAM allocation settings on SG500X models, click Administration > IP
TCAM Allocation.
The following fields are displayed:
•
IPv4 Routes—Displays the number of IPv4 routes entries that are used/
available.
•
IP Interfaces—Displays the number of used and available IP interfaces
entries.
•
IP Host—Displays the number of IP host entries used and available.
6
88
Advertisement
Table of Contents
