Cisco 500 series Administration Manual page 289

Configuring IP Information
Management and IP Interfaces
STEP 3
STEP 4
STEP 5
STEP 6
Cisco 500 Series Stackable Managed Switch Administration Guide
The following fields are displayed for the neighboring interfaces:
• Interface—Neighboring IPv6 interface type.
• IPv6 Address—IPv6 address of a neighbor.
• MAC Address—MAC address mapped to the specified IPv6 address.
• Type—Neighbor discovery cache information entry type (static or dynamic).
• State—Specifies the IPv6 neighbor status. The values are:
Incomplete
-
responded.
Reachable
- —Neighbor is known to be reachable.
Stale
- —Previously-known neighbor is unreachable. No action is taken to
verify its reachability until traffic must be sent.
Delay
- —Previously-known neighbor is unreachable. The interface is in
Delay state for a predefined Delay Time. If no reachability confirmation is
received, the state changes to Probe.
Probe
- —Neighbor is no longer known to be reachable, and Unicast
Neighbor Solicitation probes are being sent to verify the reachability.
To add a neighbor to the table, click Add. The Add IPv6 Neighbors page opens.
Enter values for the following fields:
• Interface—The neighboring IPv6 interface to be added.
• IPv6 Address—Enter the IPv6 network address assigned to the interface.
The address must be a valid IPv6 address.
• MAC Address—Enter the MAC address mapped to the specified IPv6
address.
Click Apply. The Running Configuration file is updated.
To change the type of an IP address from Dynamic to Static, use the Edit IPv6
Neighbors page.
—Address resolution is working. The neighbor has not yet
17
289