Cisco 500 series Administration Manual page 178

Smartports
Configuring Smartport Using The Web-based Interface
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
STEP 3
TIP
Configuring Smartport Using The Web-based Interface
Cisco 500 Series Stackable Managed Switch Administration Guide
5. In the Edit page, modify the fields.
6. Click Apply to rerun the macro if the parameters were changed, or Restore
Defaults to restore default parameter values to built-in macros if required.
Workflow4: To rerun a Smartport macro after it has failed, perform the
following steps:
Interface Settings
In the
Click Show Diagnostics to see the problem.
Troubleshoot, then correct the problem. See the troubleshooting tip below.
Click Edit. A new window opens in which you can click Reset to reset the interface.
Return to the main page and reapply the macro using either Reapply (for devices
that are not switches, routers or APs) or Reapply Smartport Macro (for switches,
routers or APs) to run the Smartport Macro on the interface.
A second method of resetting single or multiple unknown interfaces is:
Interface Settings
In the
Unknown
Select and click Go.
Click Reset All Unknown Smartports. Then reapply the macro as described above.
The reason that the macro failed might be a conflict with a configuration on the
interface made prior to applying the macro (most often encountered with security
and storm-control settings), a wrong port type, a typo or an incorrect command
within the user-defined macro, or an invalid parameter setting. Parameters are
checked for neither type nor boundary prior to the attempt to apply the macro,
therefore, an incorrect or invalid input to a parameter value will almost assuredly
cause failure when applying the macro.
The Smartport feature is configured in the
Type Settings and Interface Settings pages.
For Voice VLAN configuration, see
page, select an interface with Smartport type Unknown.
Port Type
page, select the
Smartport >
Voice VLAN.
equals to checkbox.
Smartport
Properties,
11
178