Cisco 500 series Administration Manual page 52
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Managing System Files
Downloading or Backing-up a Configuration or Log
STEP 5
Cisco 500 Series Stackable Managed Switch Administration Guide
The available sensitive data options are determined by the current
NOTE
user SSD rules. For details, refer to Secure Sensitive Data Management >
SSD Rules page.
c. Click Apply. The file is upgraded or backed up.
If you selected via SCP (Over SSH), see
instructions. Then enter the following fields:
•
Remote SSH Server Authentication—To enable SSH server authentication
(it is disabled by default), click Edit, which takes you to the
Authentication
Server Authentication
(password or public/private key), set a username and password on the
switch, if the password method is selected, and generate an RSA or DSA key
if required.
SSH Client Authentication—Client authentication can be done in one of the
following ways:
•
Use SSH Client—Sets permanent SSH user credentials. Click System
Credentials to go to the SSH User Authentication page where the user/
password can be set once for all future use.
•
Use SSH Client One-Time Credentials—Enter the following:
-
Username—Enter a username for this copy action.
-
Password—Enter a password for this copy.
•
SCP Server Definition—Select whether to specify the TFTP server by IP
address or by domain name.
•
IP Version—Select whether an IPv4 or an IPv6 address is used.
•
IPv6 Address Type—Select the IPv6 address type (if used). The options
are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link-Local Interface—Select the link local interface from the list.
Using the SSH Client Feature
page to configure this, and return to this page. Use the
page to select an SSH user authentication method
4
for
SSH Server
SSH
52
Advertisement
Table of Contents
