Cisco 500 series Administration Manual page 280

Configuring IP Information
Management and IP Interfaces
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 500 Series Stackable Managed Switch Administration Guide
• IP Address Type—IP address defined as static or DHCP.
- Static—Entered manually.
- DHCP—Received from DHCP server.
• IP Address—Configured IP address for the interface.
• Mask—Configured IP address mask.
• Status—Results of the IP address duplication check.
- Tentative—There is no final result for the IP address duplication check.
- Valid—The IP address collision check was completed, and no IP address
collision was detected.
- Valid-Duplicated—The IP address duplication check was completed,
and a duplicate IP address was detected.
- Duplicated—A duplicated IP address was detected for the default IP
address.
- Delayed—The assignment of the IP address is delayed for 60 second if
DHCP Client is enabled on startup in order to give time to discover DHCP
address.
- Not Received—Relevant for DHCP Address. When a DCHP Client starts
a discovery process, it assigns a dummy IP address 0.0.0.0 before the
real address is obtained. This dummy address has the status of "Not
Received".
Click Add. The Add IPv4 Interface page opens.
Select one of the following fields:
• Interface—Select Port, LAG, or VLAN as the interface associated with this
IP configuration, and select an interface from the list.
• IP Address Type—Select one of the following options:
Dynamic IP Address
-
Static IP Address
-
If Static Address was selected, enter the IP Address for this interface.
Enter the Network Mask or Prefix Length for this IP address.
• Network Mask—IP mask for this address.
—Receive the IP address from a DHCP server.
—Enter the IP address.
17
280