Cisco 500 series Administration Manual page 207
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
VLAN Management
Configuring Default VLAN Settings
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 500 Series Stackable Managed Switch Administration Guide
•
RADIUS servers cannot assign the default VLAN to 802. 1 x supplicants by
using Dynamic VLAN Assignment.
When the VID of the default VLAN is changed, the switch performs the following
on all the ports in the VLAN, after saving the configuration and rebooting the
switch:
•
Removes VLAN membership of the ports from the original default VLAN
(possible only after reboot).
•
Changes the PVID (Port VLAN Identifier) of the ports to the VID of the new
default VLAN.
•
The original default VLAN ID is removed from the switch. To be used, it must
be recreated.
•
Adds the ports as untagged VLAN members of the new default VLAN.
To change the default VLAN:
Click VLAN Management > Default VLAN Settings. The
page is displayed.
Enter the value for the following field:
•
Current Default VLAN ID—Displays the current default VLAN ID.
•
Default VLAN ID After Reboot—Enter a new VLAN ID to replace the default
VLAN ID after reboot.
Click Apply.
Click Save (in the upper-right corner of the window) and save the Running
Configuration to the Startup Configuration.
The Default VLAN ID After Reset becomes the Current Default VLAN ID after
you reboot the switch.
13
Default VLAN Settings
207
Advertisement
Table of Contents
