Adding Ip Multicast Group Addresses - Cisco 500 series Administration Manual

Configuring Multicast Forwarding

Adding IP Multicast Group Addresses

STEP 10
Adding IP Multicast Group Addresses
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco 500 Series Stackable Managed Switch Administration Guide
Click Apply, and the Running Configuration file is updated.
Entries that were created in the
NOTE
cannot be deleted in this page (even if they are selected).
IP Multicast Group Address
The
except that Multicast groups are identified by IP addresses.
IP Multicast Group Address
The
groups.
To define and view IP Multicast groups:
Click Multicast> IP Multicast Group Address. The
page opens.
The page displays all of the IP Multicast group addresses learned by snooping.
Enter the parameters required for filtering.
• VLAN ID equals to—Define the VLAN ID of the group to be displayed.
• IP Version equals to—Select IPv6 or IPv4.
• IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed. This is only relevant when the Forwarding
mode is (S,G).
• Source IP Address equals to—Define the source IP address of the sending
device. If mode is (S,G), enter the sender S. This together with the IP Group
Address is the Multicast group ID (S,G) to be displayed. If mode is (*.G), enter
an * to indicate that the Multicast group is only defined by destination.
Click Go. The results are displayed in the lower block. When Bonjour and IGMP are
enabled on switch in Layer 2 system mode, the IP Multicast address of Bonjour is
displayed.
Click Add to add a static IP Multicast Group Address. The Add IP Multicast Group
Address page opens.
Enter the parameters.
IP Multicast Group Address
page is similar to the
page enables querying and adding IP Multicast
IP Multicast Group Address
16
page
MAC Group Address
page
264