Cisco 500 series Administration Manual page 307
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Configuring Security
Configuring RADIUS
STEP 4
STEP 5
Cisco 500 Series Stackable Managed Switch Administration Guide
Click Apply. The RADIUS default settings for the switch are updated in the Running
Configuration file.
To add a RADIUS server, click Add. The Add RADIUS Server page is displayed.
Enter the values in the fields for each RADIUS server. To use the default values
entered in the RADIUS page, select Use Default.
•
IP Version—If the RADIUS server is to be identified by IP address, select
either IPv4 or IPv6, to indicate that it is entered in the selected format.
•
IPv6 Address Type—Displays that IPv6 address type is Global.
•
Server IP Address/Name—Select whether to specify the RADIUS server
by IP address or name.
•
Priority—Enter the priority of the server. The priority determines the order
the switch attempts to contact the servers to authenticate a user. The switch
starts with the highest priority RADIUS server first. Zero is the highest
priority.
•
Source IP Address—(For devices in Layer 3 system mode) Select to use
either the default source address or select one of the available IP addresses.
Key String—Enter the key string used for authenticating and encrypting
communication between the switch and the RADIUS server. This key must
match the key configured on the RADIUS server. If Use Default is selected,
the switch attempts to authenticate to the RADIUS server by using the
default Key String.
•
Timeout for Reply—Enter the number of seconds the switch waits for an
answer from the RADIUS server before retrying the query, or switching to the
next server if the maximum number of retries were made. If Use Default is
selected, the switch uses the default timeout value.
•
Authentication Port—Enter the UDP port number of the RADIUS server port
for authentication requests.
•
Accounting Port—Enter the UDP port number of the RADIUS server port for
accounting requests.
•
Retries—Enter the number of requests that are sent to the RADIUS server
before a failure is considered to have occurred. If Use Default is selected, the
switch uses the default value for the number of retries.
18
307
Advertisement
Table of Contents
