Chapter 6: Port Management; Configuring Ports - Cisco 500 series Administration Manual
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Port Management
Configuring Ports
Cisco 500 Series Stackable Managed Switch Administration Guide
This section describes port configuration, link aggregation, and the Green
Ethernet feature.
It covers the following topics:
•
Configuring Ports
•
Setting Basic Port Configuration
•
Configuring Link Aggregation
•
Configuring Green Ethernet
To configure ports, perform the following actions:
1. Configure port by using the Port Settings page.
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the
potential member ports to the desired LAGs by using the
page. By default, all LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the
LAGs by using the LAG Settings page.
4. Configure the LACP parameters for the ports that are members or candidates
of a dynamic LAG by using the
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the
Properties
page.
6. Configure Green Ethernet energy mode and 802.3 Energy Efficient Ethernet per
port by using the Port Settings page.
7. If PoE is supported and enabled for the switch, configure the switch as
described in
Managing Power-over-Ethernet
LACP
.
page
Devices.
10
LAG Management
145
Advertisement
Table of Contents
