Rebooting The Switch - Cisco 500 series Administration Manual

General Administrative Information

Rebooting the Switch

STEP 1
STEP 2
Rebooting the Switch
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
When Auto Detection is not enabled, the console port speed is automatically set to
the last speed that was set manually at (115,200 by default).
When Auto Detection is enabled but the console baud-rate was not yet
discovered, the system uses speed 115,200 for displaying text (for example, the
boot-up information).
After Auto Detection is enabled in the Console Settings page, it can be activated
by connecting the console to the device and press the Enter key twice. The device
detects the baud rate automatically.
To enable Auto Detection or to manually set the baud rate of the console:
Click Administration > Console Settings. The Console Settings page is
displayed.
Select one of the following:
• Auto Detection—The console baud rate is detected automatically.
• Static—Select one of the available speeds.
Some configuration changes, such as enabling jumbo frame support, require the
system to be rebooted before they take effect. However, rebooting the switch
deletes the Running Configuration, so it is critical that the Running Configuration is
saved to the Startup Configuration before the switch is rebooted. Clicking Apply
does not save the configuration to the Startup Configuration. For more information
on files and file types, see the
System Files section.
You can back up the configuration by using
Copy/Save Configuration
upload the configuration from a remote device. See the
up a Configuration or Log
To reboot the switch:
Click Administration > Reboot. The Reboot page opens.
Click one of the Reboot buttons to reboot the switch.
Files and File Types
Administration > File Management >
or clicking Save at the top of the window. You can also
section in the Managing System Files
section in the Managing
Downloading or Backing-
section.
6
85