Cisco 500 series Administration Manual page 217

VLAN Management
VLAN Groups
STEP 4
STEP 1
STEP 2
STEP 3
Cisco 500 Series Stackable Managed Switch Administration Guide
Click Apply to set the mapping of the VLAN group to the VLAN. This mapping
does not bind the interface dynamically to the VLAN; the interface must be
manually added to the VLAN.)
Protocol-based VLANs
Groups of protocols can be defined and then bound to a port. After the protocol
group is bound to a port, every packet originating from a protocol in the group is
assigned the VLAN that is configured in the
Workflow
To define a protocol-based VLAN group:
1. Define a protocol group (using the
2. For each required interface, assign the protocol group to a VLAN (using
Protocol-Based Groups to VLAN
and cannot have a Dynamic VLAN (DVA) assigned to it.
Protocol-Based Groups
Use the Protocol-Based Groups page to define a set of protocols.
Click VLAN Management > VLAN Groups > Protocol-Based Groups. The
Protocol-Based Groups
Protocol-Based Groups Page
The
• Encapsulation—Displays the protocol on which the VLAN group is based.
• Protocol/DSAP-SSAP—Displays the Ethernet type (two-octet field in the
Ethernet frame used to indicate which protocol is encapsulated in the
payload of the Ethernet packet) for the VLAN group.
• Group ID—Displays the protocol group ID to which the interface is added.
Click the Add Button. The
Enter the following fields:.
• Encapsulation—Protocol Packet type. The following options are available:
- Ethernet V2—If this is selected, select the Ethernet Type.
- LLC-SNAP (rfc1042)—If this is selected, enter the Protocol Value.
Protocol-Based Groups
Protocol-Based Groups
page). The interfaces must be in General mode
page is displayed.
contains the following fields:
Add Protocol-Based Group
13
page.
page).
page is displayed
217