Overview - Cisco 500 series Administration Manual

Smartports

Overview

Overview
Cisco 500 Series Stackable Managed Switch Administration Guide
The Smartport feature provides a convenient way to save and share common
configurations. By applying the same Smartport macro to multiple interfaces, the
interfaces share a common set of configurations. A Smartport macro is a script of
CLI (Command Line Interface) commands
A Smartport macro can be applied to an interface by the macro name, or by the
Smartport type associated with the macro. Applying a Smartport macro by macro
name can be done only through CLI. Refer to the CLI guide for details.
There are two ways to apply a Smartport macro by Smartport type to an
interface:
• Static Smartport—You manually assign a Smartport type to an interface.
The result is the corresponding Smartport macro is applied to the interface.
• Auto Smartport—Auto Smartport waits for a device to be attached to the
interface before applying a configuration. When a device is detected from
an interface, the Smartport macro (if assigned) that corresponds to the
Smartport type of the attaching device is automatically applied.
The Smartport feature consists of various components and works in conjunction
with other features on the switch. These components and features are described
in the following sections:
• Smartport, Smartport types and Smartport macros, described in this
section.
• Voice VLAN and Smartport, described in the
• LLDP/CDP for Smartport, described in the
Configuring CDP
Additionally, typical work flows are described in the
section.
sections, respectively.
Voice VLAN section.
Configuring LLDP and
Common Smartport Tasks
11
165