Toshiba GR200 Series Instruction Manual page 728

PWS alarm threshold setting
The IED has power supply module (PWS) at the far left slot. The user can confirm DC rated
voltage on the hardware nameplate by checking the cord at Positions '8', but the user should
select either alarm thresholds for dropping DC voltage by inserting a jumper on the PWS
Section Power supply module
(Figure 12.5-1). See
7 8
- x 1 -
Figure 12.5-1 Alarm threshold set on PWS module
CAUTION
Note: A short-wire is connected between terminal screws No. 35–37. It is done by the
manufacturer. The user shall remove that when the user undertakes the dielectric
voltage test for the IED; and the user shall connect again the terminals with that
after the test (See
Ordering positions
9 A B C D E F
x x x - x x - x x
DC rated voltage, e.g., 1='110 to 250Vdc', selected by the ordering
Appendix: Notes for the dielectric voltage test
Short wire
Type using compression terminals
Figure 12.5-2 PWS terminal labels
- 714 -
Chapter Technical description
in
G H J K L
x x - x x
- x
29
30
31
32
33
34
35
36
37
38
39
40
FG
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)
.
).