Toshiba GR200 Series Instruction Manual page 252

6F2S1931 (0.20)
Mode control function (MDCTRL)
For the user, mode control (MDCTRL) function can provide test function (TEST-FB) interface,
which is a command to change the mode in the function. MDCTRL function consists of two
parts: (1) On-mode or Test-mode sensing in IED and (2) interface between IED and SAS.
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the "G&T position" whilst
referring to the comparison table below. For more information, see Appendix: Ordering.
Table 3.8-1 Comparative table in respective ordering numbers
Ordering No. at "G&T"
Sec. Feature
30 31 32 33 34 Note
– Main features        
: Applicable NA: Not applicable

Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
- 238 -