Toshiba GR200 Series Instruction Manual page 699

Note: Setting items "On Delay timer and others" are displayed when the user sets
[BI*_CPL] On.
Binary output
(iii)
All binary output circuits provided in the IED are also user-configurable; the user can configure
timers and switches using CPL settings. (For more information of CPL, see Chapter
description: Binary IO module: Binary output circuit
Selection of binary output circuit: For example, Figure 11.6-5 illustrates the
selection of a binary output circuit on a binary IO module. Move the cursor by
pressing keys ▲ and ▼. Press key ► to go to the next level in the hierarchy.
Binary Output
10:48
Slot#1
_Slot#2
Slot#3
Slot#4
Slot#5
Slot#6
Figure 11.6-5 Selection of slot and binary output circuit
Note: This screen is a sample. The slot numbers displayed are dependent upon the
configuration of the binary IO module in each IED case.
CPL Setting: For example, Figure 11.6-6 illustrates the setting of a binary
output circuit (BO1). Using setting [BI1_CPL] On, the CPL logic in BO1 is
available. Similarly, assigned signals, timers and switches can be set in this
menu. Note that detailed setting items are shown when On is keyed into
setting [BI*_CPL].
BI1
10:48 1/3
On Delay Timer
0.000
Off Delay Timer
0.000
Inverse-SW
Normal
Figure 11.6-4 CPL setting
2/32
>
[►]
>
>
>
>
>
- 685 -
+
s
+
s
+
)
Slot#2
10:48 1/9
_BO1 >
BO2 >
BO3 >
BO4 >
BO5 >
BO6 >
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)
Technical