Siemens SINUMERIK 840D sl Programming Manual page 95

List of the result parameters
The measuring variant "Radius on sphere" provides the following result parameters:
Table 2- 12
Parameters
_OVR [4]
_OVR [5]
_OVR [8]
_OVR [10]
_OVR [12]
_OVR [14]
_OVR [16]
_OVR [18]
_OVR [9]
_OVR [11]
_OVR [13]
_OVR [15]
_OVR [17]
_OVR [19]
_OVR [20]
_OVR [21]
_OVR [22]
_OVR [24]
_OVR [27]
_OVR [28]
_OVI [2]
_OVI [5]
_OVI [9]
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
"Radius on sphere" result parameters
Description
Actual value probe ball diameter
Difference probe ball diameter
Trigger point in minus direction, actual value of 1st axis of the plane
Trigger point in plus direction, actual value of 1st axis of the plane
Trigger point in minus direction, actual value of 2nd axis of the plane mm
Trigger point in plus direction, actual value of 2nd axis of the plane
Trigger point in minus direction, actual value of 3rd axis of the plane
Trigger point in plus direction, actual value of 3rd axis of the plane
Trigger point in minus direction, difference of 1st axis of the plane
Trigger point in plus direction, difference of 1st axis of the plane
Trigger point in minus direction, difference of 2nd axis of the plane
Trigger point in plus direction, difference of 2nd axis of the plane
Trigger point in minus direction, difference of 3rd axis of the plane
Trigger point in plus direction, difference of 3rd axis of the plane
Positional deviation of the 1st axis of the plane (probe skew)
Positional deviation of the 2nd axis of the plane (probe skew)
Probe length of the workpiece probe
Angle at which the trigger points were determined
Work offset range
Safe area
Measuring cycle number
Probe number
Alarm number
Measuring variants
2.3 Measure workpiece (milling)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
-
-
-
95