Siemens SINUMERIK 840D sl Programming Manual page 203

1
Figure 2-30
①
②
③
Complete calibration
The tool probes are automatically calibrated for the "complete" calibration. Using the
calibration tool, the measuring cycle determines the tool probe trigger points in all axes or
axis directions in which the probe can be approached.
See, Commissioning Manual
"Tool measurement in milling": General setting data SD 54632
$SNS_MEA_TP_AX_DIR_AUTO_CAL or SD 54647 $SNS_MEA_TPW_AX_DIR_AUTO_CAL.
The tool axis (for G17: Z) must always be able to be approached in the minus direction.
Otherwise no "complete" calibration is possible. Calibration is started in the 3rd axis,
followed by the axes of the plane. "Complete" calibration is shown in the following screens
(example: G17).
Tool probe, disk version
Measuring cycles
Programming Manual, 02/2011, 6FC5398-4BP40-0BA0
2 3
Calibrate probe (CYCLE971) with offset axis, example G17: Determine center in X,
calibrate in Y
General SD 54627 $SNS_MEA_TP_TRIG_MINUS_DIR_AX2
General SD 54626 $SNS_MEA_TP_TRIG_PLUS_DIR_AX1
General SD 54625 $SNS_MEA_TP_TRIG_MINUS_DIR_AX1
SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Tool probe, cube version
Measuring variants
2.5 Measure tool (milling)
, Chapter
203